This "Signal" Motorcycle Will Strike

Signs Motor Will Loss - For some people, to travel overland on a motorbike would be more fun, than the car. Especially if the weather is very sunny. What about Bro and Sist? But, when it met with obstacles such as vehicles driving on strike, obvious preoccupation will be reduced. Especially if your bike broke down in a quiet place and away from the workshop. Never experienced it annoying?

signal the motor will strike

Strike itself is most often caused by an ignition problem. Both the motor still use carburetors or injection systems, ignition imperfect will make the motor suddenly stopped alias jammed. Actually, if Bro and Sist more thoroughly, then broke down in the middle of the journey will inevitably know. Because actually, the motor will provide a "signal" to the rider, if it will have to strike. However, a sign of the motor would strike, sometimes not recognized by the rider. A sign that most can be felt is the motor power is reduced. If you feel you pull the motor is weak, then it is very likely to happen to strike in the middle of the trip. In fact, strike could be detected early through a needle RPM.

"If the motor is no visible needle pointer RPM hard ride, meaning there is less good phenomenon," said Andri Irwan, from chemonk Modified modification workshop.

Motor will strike, usually also will bring up a sign in the form of exhaust sound. Usually people call "shoot-shoot". Sound "shoot-shoot" generated from the exhaust flue hole, actually due to less optimal mix between fuel combustion with oxygen. So if you already feel "signals" motor would "ngambeg", better immediately do check to the shop you trust.

Well, if we're talking about an ignition problem, which is usually the cause of the strike, we certainly will not be far away from the spark plug. Dirty spark plugs, it is quite troublesome, due to blockage of the dirt will make the work of the carburetor to be imperfect. Well, if Bro and Sist experience it, there was no need to panic too. You simply open the spark plug wires, unplug it, and wipe with a cloth, then paired again. But it must be remembered, it is only for a while, until we find a repair shop that sells plugs. The best step is to replace the spark plug that is already black. See also